Ignitor

Hot surface ignitors are use in many gas furnace applications to ignite the main burners. The ignitor will receive power after the draft inducer has been operating and cleared the heat exchanger of any leftover gases. It should glow bright orange. The gas valve will open once the ignitor has been powered long enough to reach proper temperature for ignition. The gas should light immediately. The flame will travel across the burners and reach the flame sensor on the opposite side of the burners. If the flame does not reach the flame sensor the gas valve will shut down and the process of the draft inducer clearing the heat exchanger of leftover gasses will begin again. The furnace will attempt to light 3 times and then will lock out and need to be reset by shutting off power and restoring power with the power switch. You will need a volt meter to check the ignitor. Shut off power and connect the probes on the volt meter to the 2 leads of the ignitor. Make sure the volt meter is set to read AC power. Turn power back on and watch the volt meter. If the ignitor does not glow while the power is applied the ignitor has failed. If power is never applied you may have a bad circuit board.

This is a very common failure item and should be kept as a spare. It is quite simple to change. The only tools needed are a 1/4" nut driver. Extended length with magnetic tip makes the job easier. Common cause of failure is insufficient air flow such as dirty filter or restricted ducts. Make sure registers are open and returns are not blocked and evaporator coil and blower wheel are clean. Air flow will cause the burners to cycle on limit switch. Switch may trip 8 or 10 times during a heating cycle causing ignitor to repeatedly heat up and cool down.

Displaying 31 to 52 (of 52 products)
Lennox Pilot Assembly 70L54

Lennox Pilot Assembly 70L54

Lennox furnace pilot assembly 70L54 Used with some Honeywell Smart Valve applications Replaces P/N 20093901, QP70L54 Honeywell model Q3400C1016...

$118.00



Always Free Shipping
Lennox Silicon Nitride Ignitor 70W16

Lennox Silicon Nitride Ignitor 70W16

Lennox silicon nitride ignitor P/N 70W16 Replaces Lennox P/N LB-112237B, 100536-03, LKT-03 Genuine Lennox, Ducane, Armstrong parts Shipping rate...

$108.00



Always Free Shipping
Modine Hot Surface Ignitor 5H75032

Modine Hot Surface Ignitor 5H75032

Modine hot surface ignitor P/N 5H75032 Used on many Hot Dawg style heaters Replaces P/N 5H75032A Informational video for troubleshooting hot surface...

$113.00



Always Free Shipping
Modine Ignitor 5H79636

Modine Ignitor 5H79636

Modine ignitor P/N 5H79636 Replaces P/N 5H07636, 5H076360000 Used in HD models Genuine Modine parts

$72.00



Always Free Shipping
Modine Pilot Assembly Kit 3H37454-1

Modine Pilot Assembly Kit 3H37454-1

Modine pilot assembly kit P/N 3H37454-1 Includes pilot tube and mounting bracket as well as instructions. Replaces P/N: 3H32608-6, 3H326086,...

$149.00



Nordyne Hot Surface Ignitor 903110

Nordyne Hot Surface Ignitor 903110

Nordyne hot surface ignitor P/N 903110 Replaces P/N 903110A, 9031100, 632313C, 110620-1121, FC047 Includes molex connector Informational video for...

$72.00



Always Free Shipping
Nordyne Hot Surface Ignitor 903758

Nordyne Hot Surface Ignitor 903758

Nordyne hot surface ignitor P/N 903758 Replacement kit includes brackets, wire plug and instructions Informational video for...

$67.00



Always Free Shipping
Nordyne Spiral Hot Surface Ignitor 902661

Nordyne Spiral Hot Surface Ignitor 902661

Nordyne spiral hot surface ignitor P/N 902661 Replaces P/N 902661A, FC035, 6322500 Informational video for troubleshooting hot surface ignitor...

$67.00



Always Free Shipping
Rheem Hot Surface Ignitor 62-22868-93

Rheem Hot Surface Ignitor 62-22868-93

Rheem Rudd hot surface ignitor P/N 62-22868-93 Replaces 41-408 carbide ignitor, Norton 271N, Honeywell Q4100C9054, White-Rodgers 767A-372 Genuine...

$69.00



Always Free Shipping
Rheem Spark Ignitor 62-24141-04

Rheem Spark Ignitor 62-24141-04

Rheem spark ignitor P/N 62-24141-04 Genuine Rheem, Ruud parts Shipping rate for continental United States

$52.00



Always Free Shipping
Trane Hot Surface Ignitor IGN00023

Trane Hot Surface Ignitor IGN00023

Trane hot surface ignitor P/N IGN00023. Common ignitor used on many Trane and American Standard gas furnaces Informational video for troubleshooting...

$63.00



Always Free Shipping
Trane Hot Surface Ignitor IGN00054

Trane Hot Surface Ignitor IGN00054

Trane hot surface ignitor P/N IGN00054. Replaces P/N IGN00034 Informational video for troubleshooting hot surface ignitor Genuine Trane,...

$60.00



Always Free Shipping
Trane Hot Surface Ignitor KIT03033

Trane Hot Surface Ignitor KIT03033

Trane hot surface ignitor replacement kit P/N KIT03033 Used on many Trane package models beginning with YCD15, YCD17 and YCD18 Informational video...

$125.00



Always Free Shipping
Trane Silicon Nitride Ignitor Kit IGN00145

Trane Silicon Nitride Ignitor Kit IGN00145

Trane ignitor P/N IGN00145. Silicon Nitride replacement kit. Replaces P/N IGN00104, IGN00117 Kit contains mounting bracket Informational video for...

$79.00



Always Free Shipping
White Rogers Universal Ignitor 21D64-2

White Rogers Universal Ignitor 21D64-2

White Rogers universal hot surface ignitor P/N 21D64-2 Aftermarket replacement for many common ignitors Informational video for troubleshooting hot...

$50.00



Always Free Shipping
York Hot Surface Ignitor S1-02532625000

York Hot Surface Ignitor S1-02532625000

York hot surface ignitor P/N S1-02532625000 Replaces P/N 02532625000, 025-32625-000 This is marked as 271N (Norton) but will only fit York / Coleman...

$53.00



Always Free Shipping
York Hot Surface Ignitor S1-32541021000

York Hot Surface Ignitor S1-32541021000

York hot surface ignitor P/N S1-32541021000 Replaces P/N 32541021000 Coorstek model 201N Informational video for troubleshooting hot surface ignitor...

$115.00



Always Free Shipping
York Ignitor Upgrade Kit S1-47320937001

York Ignitor Upgrade Kit S1-47320937001

York hot surface ignitor upgrade kit P/N S1-47320937001 Replaces P/N 47320937001 Includes mounting bracket Informational video for troubleshooting...

$193.00



Always Free Shipping
York Natural Gas Pilot S1-02916880700

York Natural Gas Pilot S1-02916880700

York natural gas pilot assembly P/N S1-02916880700 Includes spark electrode Genuine York parts

$65.00



Always Free Shipping
York Spark Ignitor S1-02529010000

York Spark Ignitor S1-02529010000

York spark ignitor P/N S1-02529010000 Replaces P/N 02529010000 Genuine York parts

$52.00



Always Free Shipping
York Spark Ignitor S1-02530372000

York Spark Ignitor S1-02530372000

York spark ignitor P/N S1-02530372000 Replaces  02530372000 Includes ignition lead Genuine York parts Shipping rate for continental United States

$102.00



Always Free Shipping
Goodman Hot Surface Ignitor 0230K00001

Goodman Hot Surface Ignitor 0230K00001

Goodman hot surface ignitor P/N 0230K00001 Replacement kit to replace Goodman old style ignitor P/N B1401018S with new style...

$90.00



Always Free Shipping
Displaying 31 to 52 (of 52 products)

About Us


Welcome to Shortys HVAC Supplies. We are located on the South West side of Indianapolis, IN. Our purpose is to provide Original Equipment Manufacturer parts for the repair and maintenance upkeep of furnaces, air conditioners, ventilation systems and pumps to the general public as well as contractors and commercial building maintenance staff.


We sell brand new OEM parts for most manufacturers such as Carrier, Bryant, Payne, Lennox, Armstrong Aire, Ducane, Trane, American Standard, Heil, Tempstar, Nordyne, Goodman, Rheem, Ruud, York, Coleman, Modine, Reznor, Armstrong Pumps, Bell and Gossett pumps, Weil McLain, Lochinvar, McDonnell Miller, Hoffman Specialties, Manitowoc, Scottsman and we strive to make sure you get the correct part for your application.


Give us a call with the information from your equipment nameplate and we will do our best to help. We can be reached at our local phone number 317-821-8770, Toll Free 877-821-8770 or by fax at 317-821-8772. Our physical address is 7720 S Mooresville Rd in West Newton , IN 46183. Business hours are 8-5 EST M-F. Prior to making repairs please consult your manufacturers instructions and follow all safety precautions. Improper repairs can lead to equipment damage or personal injury or death. If you are unsure of your ability please call a professional company.

Refunds And Returns

Items that are returned must be in original package and in new condition. We are not responsible for return shipping. They must be returned within 30 days of the purchase date. Any returns after 30 days will not be accepted. Refunds takes 4-7 days to be processed and appear back on the card used. A 25% restocking charge will be deducted from the original purchase price. If an item has been installed or altered in any way no refund will be processed. If you receive an item that is damaged please let us know ASAP so we can assist you.
Shipping Rate For Continental US Only. Please contact us for rates to Canada before ordering.


Trusted

COMODO SSL Secured

Contact



Company Name

Shortys HVAC Supplies LLC

Location

7720 S Mooresville RD
West Newton, IN
USA 46183

Get in Touch

877-821-8770
Email Us



About Us

Shortys HVAC Supplies LLC 2024