Goodman 0131G00093S Induced Draft Motor Replacement

Product Overview

The 0131G00093S is a 1/50 HP Direct Drive motor engineered for 230V residential and light commercial applications. Operating at a consistent 3000 RPM, this motor provides the necessary static pressure to maintain a safe draft. Featuring a durable ball-bearing design and an Open Air Over (OAO) enclosure, it is built to withstand the high temperatures and continuous duty cycles required during the heating season.

Technical Specifications

FeatureSpecification
Part Number0131G00093S
Horsepower1/50 HP
Voltage230 VAC
Phase1 Phase (Single Phase)
Full Load Amps (FLA)0.24 A
Speed (RPM)3000 RPM
Speeds1-Speed
Frequency60 Hz
Motor TypePSC (Permanent Split Capacitor)
Frame SizeFrame C
RotationClockwise (CW)
Bearing TypeBall Bearing
EnclosureOAO (Open Air Over)
Insulation ClassClass B

Compatibility and Cross-Reference

This draft motor is the factory-authorized replacement for specific Goodman, Amana, and Janitrol models requiring 230V venting solutions.

  • Direct Replacement for: 0131G00093, 0131G00093S.
  • Fits Brands: Goodman, Amana, Janitrol, and Liberty.
  • Common Applications: Used in various 80% and 90%+ AFUE gas furnace models that utilize 230V control circuits.

Symptoms of a Failing Draft Motor

If the draft motor fails to reach its rated 3000 RPM or draws excessive amperage, the furnace will lockout for safety. Watch for:

  • The "Humming" Lockout: You hear the motor hum when the thermostat calls for heat, but the fan never spins, preventing the pressure switch from closing.
  • Screeching or Grinding: Loud mechanical noises often indicate that the internal ball bearings have failed due to age or heat stress.
  • Pressure Switch Fault Codes: If the control board flashes a code for an "Open Pressure Switch," the motor may be spinning too slowly to create a sufficient vacuum.
  • Overheating: If the motor housing is hot to the touch and the motor shuts off intermittently, the internal thermal protection is likely tripping.

Installation and Safety Tip

When installing the 0131G00093S, always inspect the centrifugal blower wheel for rust or debris buildup, as an unbalanced wheel can lead to premature motor failure. Ensure all electrical connections are secure and that the motor is properly grounded. Always disconnect the 230V power supply and shut off the gas valve before performing any repairs.

Shipping Information

  • Continental US: Reliable shipping is available for all orders within the lower 48 states.
  • Fast Fulfillment: We prioritize draft motor orders to help you restore your heating system as quickly as possible.
  • Genuine Quality: We stock only original Goodman parts to ensure safety limits, mounting alignment, and electrical connectors match your equipment exactly.

Order your genuine Goodman 0131G00093S induced draft motor today from Shorty’s HVAC Supplies and keep your furnace venting safely.

$258.00

Add to Cart:
  • Model: 0131G00093S
  • Manufactured by: Goodman
Ask a Question

Manufacturer Info