Goodman Flame Sensor 0130F00010

Goodman / Amana 0130F00010 Furnace Flame Sensor | Genuine OEM

The Goodman 0130F00010 is a genuine factory-authorized flame sensor designed for use in a wide variety of Goodman, Amana, and Janitrol gas furnaces equipped with hot surface ignition (HSI). This Original Equipment Manufacturer (OEM) part is a critical safety component that monitors the burner to confirm a flame has been established, preventing the buildup of unburned gas.

Troubleshooting: Flame Sensor Failure Symptoms

If your furnace is experiencing issues, the flame sensor is a common culprit. A failing or dirty sensor typically causes the following behavior:

Short Cycling: The flame ignites successfully but shuts off after approximately 3 seconds.
Lockout Mode: The system will typically attempt to ignite 3 times before locking out and displaying a flame failure fault code (often a blinking LED on the circuit board).
Carbon Buildup: Over time, "soot" or oxidation can coat the rod, insulating it from the flame and preventing it from sending the microamp signal to the control board.

Compatibility & Cross-Reference

The 0130F00010 is a versatile part used in most modern Goodman-branded gas heat systems.

OEM Product Replaces: B1172606, B11726-06, 0130F00010S, 20488501, 0130F00010.
Common Model Series: Compatible with GMP, GMPN, GDT, GMT, GMTH, and GMNT series furnaces.
Brand Compatibility: Fits Goodman, Amana, Janitrol, and some Daikin and ICP units.
Better Quality than the aftermarket Supco version sold elsewhere.

Why Choose a Genuine Goodman OEM Sensor?

Safety First: OEM sensors are calibrated to the exact microamp specifications required by your specific control board.
Direct-Fit Mounting: Features the correct offset and mounting hole alignment for a "no-leak" fit in the burner vestibule.
Durable Materials: High-grade ceramic and specialized metal alloys ensure a longer service life compared to generic universal "will-fit" rods.