Carrier Blower Motor HC43TQ113

Carrier HC43TQ113 Blower Motor | 1/2 HP, 115V, 1075 RPM

Restore dependable, factory-spec performance to your HVAC equipment with the Carrier HC43TQ113 Blower Motor. This Genuine OEM Factory Authorized Part is built to the exact mechanical and electrical configurations required for Carrier, Bryant, and Payne residential units.

It comes pre-configured with 4 welded mounting arms, isolation grommets, and standoff sleeves attached to the housing. Wiring leads match factory colors, lengths, and terminal connections perfectly for a true drop-in, zero-modification installation.

Product Specifications

• Part Number: HC43TQ113
• Horsepower: 1/2 HP
• Voltage: 115 V
• Speed: 1075 RPM (3-Speed)
• Amperage: 7.90 A
• Frequency: 60 HZ
• Phase: 1 PH
• Mounting: 4 pre-attached flex arms with rubber grommets and steel standoff sleeves
• Capacitor Requirement: Requires a 10 µF / 370 VAC run capacitor (not included)
• Manufacturer Cross-Reference: GE / Genteq Model 5KCP39LGV569BS

Compatibility & Replacement

• Replaces Part Numbers: HB43TE113, HB43TR113, HC43TE113
• Equipment Brands: Carrier, Bryant, and Payne
• Application: Residential indoor gas furnaces, fan coils, and air handlers

Why Choose Genuine OEM?

Unlike universal aftermarket alternatives, this Genuine Carrier part features a precise drop-in bracket design and factory-exact electrical ratings. Choosing a Factory Original component prevents mounting alignment issues, eliminates excessive electrical strain, and ensures whisper-quiet operation.

Part Verification Support

If you would like to verify this part is correct for your application, please call or email us via our Contact Us page. Provide the full product model and serial number from the data tag on your gas furnace, and we will be happy to verify the proper replacement part for you.

Shipping Information

• Service Area: Standard shipping rates apply to the continental United States only.
• Other Locations: Please contact us directly for an accurate freight quote to locations outside the continental US.

Pro-Tech Installation Tip: Verify your equipment schematic before installation. Always replace the run capacitor alongside a new motor to ensure optimal starting torque and protect the new windings. Any speed leads not utilized by your system control board must be individually capped with wire nuts or parked on dead terminals to prevent electrical short circuits. Verify that the blower wheel is clean and balanced before securing the hub set screw to the flat side of the motor shaft.