Carrier HC42AQ193 Blower Motor 1/3 HP, 1075 RPM, 3-Speed

Restore dependable, multi-speed air delivery to your HVAC equipment with the Carrier HC42AQ193 Blower Motor. This Genuine OEM Factory Authorized Part is a high-quality PSC (Permanent Split Capacitor) induction motor engineered to meet the exact electrical and mechanical specifications required for Carrier, Bryant, and Payne residential furnaces, fan coils, and air handlers.

Technical Specifications

• Part Number: HC42AQ193
• Motor Type: PSC Induction Motor
• Horsepower: 1/3 HP
• Speed: 1075 RPM (3-Speed)
• Voltage: 208/230 VAC
• Frequency: 60 HZ
• Amperage: 2.70 A
• Phase: 1 PH
• Capacitor Requirement: Requires a 15 µF / 370 VAC run capacitor (not included)
• Manufacturer Cross-Reference: GE / Genteq Model 5KCP39KGS081S

Direct Replacement & Compatibility

The HC42AQ193 serves as the factory-authorized direct successor for several older motor designs. Selecting a Factory Original part guarantees that the physical frame size, motor shaft length, and electrical lead wire configurations align precisely with your existing system, eliminating the mounting modifications or complex troubleshooting often associated with generic aftermarket motors.

• Replaces Part Numbers: HC41AE193, HC41AE193A
• Equipment Brands: Carrier, Bryant, and Payne.
• Application: Residential indoor gas furnaces, fan coils, and air handling units.

Why Choose Genuine Carrier OEM?

Indoor blower motors run continuously under heavy static pressure loads to maintain proper cubic feet per minute (CFM) across your heat exchanger or cooling coil. Substandard universal replacements often pull higher amperage than rated, causing the motor to overheat and trip its internal thermal overload prematurely. This Genuine Carrier motor is engineered for low vibration, minimal noise, and strict thermal compliance, ensuring long-term reliability and efficient operation.

Shipping Information

• Service Area: Standard shipping rates apply to the continental United States only.

Pro-Tech Installation & Wiring Tip: When installing a multi-speed PSC motor, proper wire configuration and capacitor maintenance are essential.

• Capacitor Replacement: Always install a brand-new 15 µF / 370 VAC run capacitor when replacing this motor. Running a new motor with an old, out-of-tolerance capacitor will restrict starting torque, cause the motor to draw excessive amperage, and quickly burn out the new windings.
• Speed Taps: This motor features 3 distinct speed leads to accommodate varying heating, cooling, or continuous fan settings. Any speed leads not utilized by your system control board must be individually capped with wire nuts or parked on dead terminals to prevent electrical short circuits.
• Clearance Check: Before restoring power, secure the motor firmly within its belly-band bracket, verify the blower wheel set screw is tightened securely onto the flat part of the motor shaft, and spin the assembly by hand to check for smooth clearance within the housing.